Featured
Turning On Your Sprinkler System
Turning On Your Sprinkler System. Find the system's main shutoff valve, which will be located between your home's main line and the irrigation system's backflow preventer. If your sprinklers didn’t turn on, then you’ll need to try to open the isolation valve.

Slowly open the main valve. Make a note of the current settings and change them to meet your lawn and landscape’s spring watering. The valve to turn on the water is usually near your water meter inside the house.
Your Supply Pipes Can Break Due To Ground Pressure Or Tree Roots.
That includes taking all the proper steps when turning your sprinkler on in the spring. 2) go to the main tap turn on in the house and open the valve slowly. Turn your main water to your sprinkler on.
It’ll Turn On Whenever You (Or Whoever You Hired) Turns It Back On.
Testimonials team members careers blog contact us request sprinkler estimate request sprinkler service pay online sprinkler installation The heads can be moved by bumps from a passing foot or. You may find this switch located near where you would turn off the sprinklers if it were to rain.
Once The Line Is Filled, Go To The Backflow Preventer And Open The Lower Ball Valve.
It’s very important to turn on the water gradually, otherwise you can create a water hammer that can damage your system. Turn the valve handle slowly to fill the lines between there and the backflow preventer. Turn screws ( a) so they are perpendicular to the fitting (up and down).
Large Volumes Of Water Can Cause Overwatering That Can Damage Your Lawn And Plants.
You should hear water running for a few seconds then stop. 3) go back outside to the back flow device and. Need help turning on the water supply for your irrigation system?
The Force From Water Hammer Can Cause Leaks, Burst Fittings, And Even Pop Off Sprinkler Heads!
Locate the shut off valves. If there is a bleeder cap (a small metal cap that's twisted on the main valve), it was likely loosened or removed in the fall to make sure all water was drained from the system. You want to override the automatic settings by turning on the manual cycle so you can slowly let the water flow throughout the irrigation system.
Comments
Post a Comment